Houston Astros Logo Wall Art - No AMS or MMS Needed
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Houston Astros Logo Wall Art - No AMS or MMS Needed
- Rating
- 0 / 5
- Likes
- 12
- Downloads
- 103
- Makes
- 0
- Views
- 507
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- 2D Plates & Logos
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
My home office needed some sprucing up with 3D-printed Houston sports decorations. These are available in two sizes: 190mm and 264mm in diameter.
Because I do not own an AMS or MMS, this “puzzle-like” design allows you to print each piece in your choice of colors. My K1 Max was tuned and calibrated for the PLA filament listed below. These were designed with a .15mm tolerance, so each piece snuggly fit without issues for me. I did use a few dabs of CA glue to secure each piece.
I drilled a tiny hole through the 3D print for a picture-hanging nail to hang these on my wall. You could also use Command strips.
SETTINGS
Orca Slicer is my preferred slicer of choice.
Layer Height: 0.2mm
Infill Density: 10%
Infill Pattern: Cross Hatch
Wall Loops: 3
Top Layers: 5
Bottom Layers: 3
Support Needed: No
FILAMENTS USED
Blue PolySonic PLA
Orange Print Bed PLA
White Overture PLA