Workshop top (Lars homestead)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The top of the Lars homestead workshop that can be seen from the surface.
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 66
- Makes
- 0
- Views
- 347
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Toys & Games
- License
- Creative Commons — Attribution — Share Alike
The top of the workshop on Lars homestead that can be seen on the surface.
You need to print 4 of both the top and bottom sections. I only used supports under the connector pins. Once printed I glued the sections together, filled any gaps, put some sand on the surface (to give a corroded look) and then painted it.
You should be aware these files are an absolute mess! I have got them all to slice in PrusaSlicer but can't say for others slicers. If you want to modify them you would probably be better to just start afresh.
This is part of a larger project where I built Lars homestead as a backdrop for photos of a Lego landspeeder. The other parts of the project can be found below:
Entry dome - https://www.prusaprinters.org/prints/98051-entry-dome-lars-homestead
Droids - https://www.prusaprinters.org/prints/98160-eg-6-and-wed-15-droids-lars-homestead
Vaporators - https://www.prusaprinters.org/prints/98157-vaporators-lars-homestead
Assorted props - https://www.prusaprinters.org/prints/98303-mixed-props-lars-homestead
The pit - https://www.prusaprinters.org/prints/98353-the-pit-lars-homestead
Key ring - https://www.prusaprinters.org/prints/98203-stormtrooper-keyring
Project video -