1 / 3
Storz & Bickel Mighty & Crafty+ POTV Water Pipe Adapter Modified for Venty — image 1
1 / 3

Storz & Bickel Mighty & Crafty+ POTV Water Pipe Adapter Modified for Venty

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A modified plastic adapter that accepts the Mighty & Crafty+ Glass Adapter from POTV and fits on the Venty

Rating
5 / 5
Likes
7
Downloads
124
Makes
1
Views
971
Reviews
1

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

I had a water pipe adapter (WPA) from Planet of the Vapes (POTV) for my Storz & Bickel Crafty+.  Unfortunately, it didn't fit the Venty.  So, I spent some time learning Fusion to create a modified plastic ring to fit the Venty.  It uses the same frosted glass insert, just remove it from the Mighty/Crafty plastic ring, and insert it into the printed one that fits the Venty.  It should work with the 18mm and 14mm versions of the frosted glass piece.

Some Notes

The tolerances on this model are a little tight.  You may need to adjust your expansion/shrinkage settings for the material if things end up being too tight.  The frosted glass piece fits snug into the plastic adapter, make sure it's fully seated.  It should be pushed all the way into the plastic adapter.  The glass won't be flush with the bottom of the plastic adapter like with the Mighty/Crafty version of the plastic adapter.

I'm going to copy over the same advice as the POTV page for this: Be sure not to twist the glass adapter too much, as this can damage your vaporizer.  

You will find that the plastic adapter won't rotate fully into the locking clasps.  It doesn't need to, so don't force it.

Material

I used Polymaker Black ASA to print it, figuring that I'd want something that could be a bit heat resistant and also durable.  PETG might be fine.  If you have the capability though, the material the vaporizer is made from is PEEK (from what I've read) which is much more heat resistant than ASA or ABS.

Layer Height

I printed with 0.2mm layers with a 0.4mm nozzle.  You could also try 0.12mm layers (or whatever finer layer height mathematically makes sense for your printer) to get better detail on the quarter threads at the base of the adapter.

Supports/Overhang

There is a bit of an overhang at the top which acts as a stop for the glass part of the adapter.  I'm able to print it fine without supports.  You may get a couple hairs in the process though.  Cura seems to handle it better than PrusaSlicer for some reason.  PrusaSlicer for me printed 3 perimeters in mid air (???), and then a bridging pattern that worked fine on the next layer.  Feel free to use supports but I don't think it's totally necessary.

Final Notes

Use at your own risk.  Keep in mind this adapter will essentially be in close proximity to the heat chamber, and I cannot speak to the potential risks involved with this.  As such, I am not responsible for any damage to your device, adapters, your health, and the like.  Feel free to remix this or adapt the model.  I better not see this crap on Etsy or Cults or whatever!  

If you feel so inclined to support my myriad of basement hobbies feel free to donate!

Tags