Power Plug Case for Mounting on 2020 Aluminum Extrusions
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is my mount for the power connector of my Hypercube build. I use this power connector with a switch:…
- Rating
- 5 / 5
- Likes
- 40
- Downloads
- 141
- Makes
- 1
- Views
- 722
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is my mount for the power connector of my Hypercube build. I use this power connector with a switch: https://www.banggood.com/3-in-1-Fuse-Power-Supply-Socket-for-Makerbot-Ultimaker-p-1051419.html
However i replaced the 2 pin switch with a 4 pin switch to break both power lines to ease my mind. Got mine from here: https://www.ebay.de/itm/Wippschalter-H8550VBACA-Schalter-2-polig-EIN-AUS-10A-250V-AC-schwarz-I-O-855226/183034200775
You need:
- 2 8mm M5 screws
6 M3 screws (length: 5mm and above up to ~20mm) The holes for the M3 screws are threaded.
In the .zip file are other iterations of my design where i did not enclose the internal connections. This makes the housing thinner and you can use cable connectors but you have more wires outside.
I finally decided to use a full enclosed version. The wires need to be soldered there. The cable hole has a diameter of 9mm.
The housing needs to be screwed to the extrusions fist before inserting the connector.
(Imported from https://www.thingiverse.com/thing:2922760)