1 / 4
DIY Hakko 936 Soldering Iron - ABS/ASA filament — image 1
1 / 4

DIY Hakko 936 Soldering Iron - ABS/ASA filament

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Custom case for the world's most popular soldering iron!

Rating
0 / 5
Likes
2
Downloads
39
Makes
0
Views
354
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution

The Hakko 936 is a time-tested design and spare parts are plentiful.  I prefer analog controls over buttons, so I put this together with a transformer I salvaged out of a Weller station.

This case is designed to be ABS-friendly.  You can print individual panels to eliminate part warping.  Or, you can print them pre-assembled in PLA where warping is not a problem.

Assembly is simple.  The side panels are screwed to the base with heat set inserts. These panels have slots to retain the front and rear panels.  You then glue the top on with ABS slurry, acetone, epoxy, CA glue, or the appropriate adhesive.

The supplied feet conceal the screws that fasten the cover to the base.

To complete the project, source these non-printable items:

  1. 24V 50VA transformer
  2. Hakko A1321 iron
  3. Hakko 936 control board
  4. Rocker switch
  5. (Optional) Fuse to protect transformer

Hardware:

  1. Four M3 screws and heat set inserts to fasten the cover
  2. Two M2.5 wood screws for power cord strain relief
  3. Four M4 screws for transformer

When printing, please use a more colourful scheme than gray :)