Super Agitator
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This works with the cheap magnetic mixing plates avail on Amazon and Ali Express as well as others.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 9
- Makes
- 0
- Views
- 111
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Share Alike
I created this set of parts to work with my westune mag mixing plate from amazon. it will work with most mixing plates out there. it uses small magnets from ali express or amazon. i used the 3d printed 608 BB ball bearing while designing this thing so any 608 bearing will work.
I used CA glue to affix the bearings on the axles and the magnets into the pockets. I originally printed on an anycubic photon mono 2 printer but I had limited success also on my tronxy x5sa fdm with petg.
I double stacked the magnets to increase the coupling to the mixing plate. these work best with thin bottom containers that sit flat on the mixing plate.
P.S. make sure the polarity of the magnets is correct for the mixing plate. I put the magnets on the mixing plate so that they stuck on it then marked the top with a sharpie.