1 / 5
Pendant Slide Ocarina
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A small Ocarina that can be worn as pendant or keychain.
- Rating
- 5 / 5
- Likes
- 47
- Downloads
- 285
- Makes
- 5
- Views
- 1,121
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Music
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
I will publish new Ocarinas only on MakerWorld.
https://makerworld.com/en/@E.CAN3
This is a funny little toy.
So… this ocarina is not in a specific tune.
It is loud and annoying.
It is fun to play.
How to use it:
Close the slot with a finger of your right hand for the lowest note.
Slide your chosen finger to the right to increase the pitch + blow a little bit harder.
Don't block the soundhole on the back!
I print them with:
- 0.4 mm nozzle
- 2 walls
- 0.2 mm Layer hight
- 4 Top and Bottom layers
- Wall Ordering: Outside To Inside - Walls before Infill.
- 20% Infill - Gyroid
- 5mm Brim
- No Support
Important
- Make sure your bed adhesion is good, else it will fail, so… clean your bed before printing!
- Avoid stringing
- Avoid Z-Seam on the labium
- Have fun!