Keyholder Swiss knife style with AirTag compartment
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€1.08 – €1.32 net (excluding VAT)
For file: Keyholder Swiss Style v13_Top_0.4n_0.15mm_PETG_MK4IS_1h6m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €1.20 excluding VAT (range midpoint).
- Weight reported by the author
- 18 g
- Print time reported by the author
- 1.11 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
This is a follow up on a previous design. This time with a a compartment for an Apple AirTag
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 27
- Makes
- 0
- Views
- 226
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I already designed a key holder that looks like a swiss pocket knife.
I am using it since several years now.
You can find that design here:
https://www.printables.com/model/46565-yaskskh-yet-another-swiss-knife-style-key-holder
This time I wanted to integrate an Apple AirTag. The difficulty is to keep the design as small as possible, because I like to cary the keys in the pockets of my jeans.
You can see the result in the pictures.
Important is that the keys are on both ends and the keys from both sides are next to each other. You have to organise a bit to get the best distribution between both ends. Because both stacks will likely not be equal I also made two different “fillers”.
You can get the keys out by pushing through the indents of the covers. Over time you learn to do that with one hand.
For assembly you need two M3 screws. The length of the screws depends on the height of your key stacks. You need to tighten these screws so that there is a bit friction between the keys. Likely you have to cut them.
I also strongly recommend to use self locking nuts, so the friction will stay the same for a long time. Alternatively you can use Locktite (The type that you can still loosen afterwards...)
I printed the model in PETG with 0.15 mm layer and 15% infill.
As always, when you print this please give me feedback and post some pictures.