Skadis Self Align T-Nut (M2.5)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remixed t-nut for Skadis pegboard mount system. No need to add alignment guide, better bed adhision.
- Rating
- 0 / 5
- Likes
- 18
- Downloads
- 81
- Makes
- 0
- Views
- 586
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution
Use Tips
Hole diameter = 3mm
On the mounted object, put holes with 3mm diameter. The M2.5 bolt should freely move without any friction in the hole. If not, the t-nut might not rotate full 90 degrees on the other side of the board. Some friction on the spacer and t-nut is okay and even helpful. It is only the hole on the mounted object that needs more clearance. When mounting, first slowly turn the bolt 180 degress counterclockwise, then turn clockwise fast enough to make sure the t-nut rotates in place.
Recommended print settings
PETG, 3 perimeters, layer height 0.2mm, avoid crossing perimeters, 80~100% cooling. Expect 10% defect rate: print more parts than you need. Discard parts with stringing and only use relatively clean ones.
Hardware specification
Get DIN934 M2.5 bolt and nuts. Decide the length of bolt depending on the thickness of your model's “wall”. I use 14mm bolt to mount 3.5mm thick plate. Rule of thumb: bolt length - 10 mm = (your model's wall thickness)