DJI Air 3 grab handle/landing gear
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Allows easier hand catching of the drone and landing on rough surfaces
- Rating
- 0 / 5
- Likes
- 28
- Downloads
- 192
- Makes
- 1
- Views
- 966
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Share Alike
Hand catching the DJI Air 3 from a moving boat can be challenging. These grab handles make it a lot easier. They also allow you to land on rocky or sandy areas that would usually not be safe.
The hinge joints are a print in place flexible design - I've printed them in CF-Nylon. TPU would probably work as well. PLA, PETG, ASA are probably not going to work. Your printers tolerances will need to be pretty good to stop the hinge bits sticking to each other - you can slice it open with a sharp knife if need be.
The retaining clips are also printed in CF-Nylon. They clip in easily but require a bit of effort to remove - try scaling them down if it's too much effort. PETG might be acceptable for the clips but I haven't tried it.
I printed with two perimeters and 15% lightning infill and weight is under 60g for the set. Print lying flat (as shown in screenshot) for optimal strength at the hinge joints.
Test flights have shown no interference with the sensors so far.