Motorless Combat Robot/Battlebot
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
If you liked my last model but don't have the motor for it, don't worry! 99% 3D Printed; uses only a rubber band.
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 23
- Makes
- 0
- Views
- 443
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Please like or comment
This is actually another edition of my motorized model, but no overlap in the pieces
If you liked my last model but don't have the motor for it, don't worry! 99% 3D Printed; uses only a rubber band for power
Print weapon and frame, both axles, and normal lid.
Instructions for assembly:
Slide “axle 2” through hole on side of frame then through the weapon
The clip at the end should be vertical
Slide “axle 1” through other hole, weapon, and axle 2
Both clips should be vertical
Slide both clips to facing towards the back of the frame
Cut rubber band in half
Stick one end through each hole in the front of the frame
Tie each end around the “anchors” in the body
Put the loop of the rubber band around the big tooth on the weapon and twist forward to wind up