In-Ceiling Speaker retention clip
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement part for (most) common in ceiling speakers
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 33
- Makes
- 0
- Views
- 128
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I have dozens of in-ceiling speakers installed around my entire home and outside around my pool. This past summer we repainted the entire home and the speakers needed to be removed. Upon re-installation the contractor notified us that the retention clips had deteriorated over time and were no longer able to be used to hold the ceiling speakers in.
I contacted the speaker manufacturer and they said they do not make replacement retention clips and that my only option was to purchase new speakers at $280+ EACH. This is unacceptable. I spent 30 minutes designing this and another half hour printing some until I had a 1:1 match to the original. My contractor could not understand how I duplicated this and printed it. I had to show him what a 3d printer was. It melted his mind.
Print this in PETG or ABS if you intend to use these on OUTDOOR ceiling speakers. Printing in PLA/PLA+ is fine if they are going to be used indoors.
4-6 walls 45%+infill. No supports needed.
I simply hope this helps someone.