RPI Zero 2 Camera
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€1.67 – €2.04 net (excluding VAT)
For file: Base-and-Cover-v1_0.4n_0.15mm_PLA_MK4IS_1h48m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €1.85 excluding VAT (range midpoint).
- Weight reported by the author
- 24 g
- Print time reported by the author
- 1.81 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Compact case for Raspberry Zero 2 and 170 degree wide angle camera with 1/4-inch tripod mounting holes
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 30
- Makes
- 0
- Views
- 281
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution — Share Alike
Introduction
Earlier this summer I had to throw together a “quick and dirty” setup for a bird camera and decided to have a better solution next time with multiple use cases. This is what I came up with. This is a compact case for Raspberry Zero 2 and 170 degree wide angle camera with 1/4-inch tripod mounting holes. I couldn't find a compact case that would work for a wide angle camera so decided to design my own.
Case Instructions
The case is a “snap-to-fit” design so you will want to print with high precision. The boards are both mounted with screws to the base of the case. Use M2.5 for the Pi Zero and M2 for the camera board. You will also need a very short ribbon cable. Links to the parts I used will be provided below. There are tripod holes on three sides of the case that will allow you to select a desired camera orientation.
Hardware List
- Raspberry Pi Zero 2 W
- 175 Degree OV5647 Sensor 5MP Camera Module
- Raspberry Pi Camera Cable 4CM
- Mini Tripod
Note: You will also need other HW (sd card, power source, etc.)
Tested Print Settings
- Prusa MK4
- No Supports
- 0.4mm nozzle
- Sliced - .15mm (Structural)
- HatchBox Black PLA
Total Print Time: 1hr48min