Swift Sixteen Tyre Truer Sanding Plate Reciprocation Machine
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
so your hands are free to do other things!
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 26
- Makes
- 0
- Views
- 402
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A customer wanted one of my reciprocators for his Swift Sixteen machine. He took all the appropriate measurements of the machine so that I could adjust my design to suit that machine. Photo and video of the reciprocator on a Swift Sixteen are courtesy of him. Thanks, Daryl!
While this was completely redesigned from scratch, I still owe thanks to OXO_Cube for his original machine that I based my Tire Razor Reciprocator from. I also owe some thanks to Kev Ster, who remixed my version for the RSM machine, and made some clever changes. I took some inspiration from his changes to further improve and simplify this one for the Swift Sixteen machine.
As the motor can warm up during use, I recommend a temp resistant material such as PETG or ABS for the gantry and rotating arm parts. The rest can be PLA if you want. I usually print the bases in PLA, and all the small parts in PETG.
This uses a GA12-N20 gearmotor. Get the lowest RPM at the highest voltage you can. E.G. a 15rpm at 6v would be good. You will also need some m1.6-0.35mm x5mm screws to mount the gearmotor. Since the only ones I could get quickly at a reasonable price were 6mm long, that's what I designed the gantry for, so that they can be snug without interfering with the gears of the gear motor. 5mm long screws will probably work fine, but not longer than 6mm.
The rest of the screws I used are just M3 socket head cap screws as are popular on various 3D printers like my Prusa. Any M3 screw should work, just be careful that the head does not collide with anything prior to use. I use a 6mm one to secure the Pushing Arm to the Rotating Arm and the Rotating Arm to the motor shaft. I would recommend 10mm for the screws on the clamps so they are less likely to strip when tightening the clamps down. A 6mm screw is also good to secure the gantry to the base. I also use one M3 square nut in the Rotating Arm to give the M3 screw better grip strength on the motor shaft.
When attaching the ball hitch to the end of your sanding plate, try to get it as centered on the end of the sanding plate as possible. This will ensure that the reciprocator arm lines up nicely with it. You can use a strong glue, or thin double-sided tape. Putting a ball joint on both ends of the sanding plate will allow you to easily turn it around and possibly use fresh sanding surface, depending on the wheels/tires you are truing.
The STL files are all provided in the ideal print orientation. No supports should be needed for any of the models if printed in the provided orientation.
STEP and Fusion 360 files are also included to make it easier to modify for your particular machine if needed.
If you would like a machine, feel free to contact me at [email protected] to order one.
For more information about the Swift Sixteen Tyre Truer, and other products from Swift Slots, check out his web site:
https://www.swiftsixteen.co.uk/target-room
For a better understanding of what all the parts are for and how to install them, review this video about my reciprocator for the Overdrive RSM4, which is very similar apart from the hardware differences mentioned above.