Magnepan LRS / LRS+ and MG.7 Stands
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Rigid vertical stands for Magnepan LRS / LRS+ and MG.7 speakers. Corrects factory tilt to 90° for improved imaging.
- Rating
- 5 / 5
- Likes
- 7
- Downloads
- 154
- Makes
- 1
- Views
- 598
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Audio
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Using the existing mounting holes and screws, these stands will hold your Magnepan LRS / LRS+ or MG.7 panels vertical and raise them approximately 2” or 3” (LRS / LRS+ only) depending on which version you choose.
There are some versions with 9mm clearance holes if you decide to add generic aftermarket 8mm threaded spikes.
I used Orcaslicer to slice the part with 10% gyroid infill, 0.24 layer height, and 3 walls for the LRS stands. However, I added modifiers to increase the infill to 50% (rectilinear) around the screw holes to make this area stronger as shown in the picture. Printed with Eryone Black PETG.
NOTE:
LRS/LRS+ versions are 38mm wide and have a 2.0" (50.8mm) bracket hole spacing.
MG.7 versions are 50mm wide and have a 52mm bracket hole spacing.
Please verify mounting hole spacing before printing.
Recommended print settings:
Material: PETG or PETG-CF (some users have used ASA)
Layer height: 0.24 (or smaller)
Infill: 15% gyroid (minimum)
Walls: 3 (minimum)
Add modifiers around mounting hole areas for increased strength (as shown)
*** 07-2026 Magnepan .7 Versions Added - VERIFIED AND INSTALLED BY USER ***
Please measure and/or test with the fixture before printing. I do not own a set of .7's - I can only rely on communication and photos of these stands in use. Therefore, please measure your mounting holes and/or test with the fixture before printing. Be sure you're comfortable with the stability of the speaker after these are installed - I assume no responsibility for speaker damage.
*** 07-27-2026 Magnepan LRS/LRS+ Larger Versions Added***
Added 2" lift designs that can be printed on 300mm and 350mm for increased stability. 300mm stand shown in picture with comparison to original 220mm stand.