Counting matching models…
The Balboa Racing iStart is a common fixture in small boat racing. Having used one both coaching, and in community sailing programs, I've also had to service a few of them. Batteries are intended to be “replaceable” by the manufacturer,…
Print approx. €13.01–€15.90 excl. taxPreliminary estimate for one variant
This stand has a small slot in the back for coins that will ballast it. I used three nickles and a penny, the stack wedges in. Pebble Time 2 doesn't come with a slim right angle cord so a USB C cord just sticks out the side.
This remix fits a round puck base with an 80mm diameter. Scale up/down by small percents to achieve the fit you want. This version is sealed. Perform a cut operation on it if you want it open, or add additional modifiers. The clearest…
This model is two parts, a base that contains most of the charging circuit, where the buttons and LEDs are attached, and a frame that retains the transceivers and snaps into the vehicle interior. The 2011 Silverado overhead console is GM…
Mounts on the LED rail. I ran my cable up and over and then down along the side. Probably best with a 120 degree model, I use the 75 degree camera module 3 I believe.
These are fender liner grommets for VW wheel arches, extensions, bumpers, and undermounts.
This small puck houses a 24 Neopixel ring and a MagWLED-1 wifi driver/controller . A shade is not included in this listing as this model is original but the honeycomb shade pictured is a remix. Things mostly snap fit but I added hot glue…
Similar to other options but a little wider for strength, and with fillets.
Update to take some slop out of the right side. They're also pushed off a bit to allow for more space for right angle connectors. I damaged a Pi's power port with the tension required.
This small work stand has two pegs ~30mm apart for holding Zama carburetors. The one I'm currently working on is off a Stihl MS261c, I'm not sure the exact model. The vertical piece should be printed on its angled base for extra peg…
Features Timemore Black Mirror Nano digital scale garage Raises machine to allow for cup to sit on a scale 1Zpresso JX-Pro manual grinder slides into tube Place for the original Uniterra tamper Stores one extra Uniterra coffee drawer…
The end connections may not work out of the box for you but they're easy to slice off and replace. I use an 8mm COB warm white scrap strip.
This may or may not fit your screw layout. 2x McMaster SKU 92552A429 - Steel Low-Profile Knurled-Head Thumb Screw, M4 x 0.7mm Thread Size, 12mm Long
V2 Update 8/19/2025: Removed some material on the SDR dongle cage to allow for access to the rest of the NUC's ports. Packaged as shown in the photograph the radio is overwhelmingly likely to receive too much interference to work…
Glue this in the latch gap to skip over locking mid-way out/in.
This is a set of prints that will house Xprite 52026Ts , which I was able to find in an 8 pack. The light facades fit snugly into aluminum architectural U-channel that I got off McMaster , but will need to be weather sealed. I used a…
These are all currently available results.
