Counting matching models…
This is a simple hammer holder that I remixed from the original design from NasBoc. I just eliminated the holes and added an hexagonal attachment for the Honeycomb Wall. I printed it in PLA and it comes out very sturdy. Support are…
I remixed the Hammer holder by NasBoc to adapt it to my pegboard from Lidl/Parkside. I have removed the wall mount holes from the original model and added a two vertical pins bar to fit the Lidl/Parkside pegboard. I also made another…
This is another holder for the Knipex pliers wrench (model 87 01 250). It fits the Lidl/Parkside pegboard. My Printing Settings Nozzle : 0.4 Layer Heigth: 0.2 mm. Infill: 15% Supports: YES
I remixed the original insert-empty by @RostaP. The intent was to have a support for the honeycomb wall in which I can insert a threaded brass insert instead of an insert that needs a nut. What I done: First I made the insert full On the…
I printed it in PLA from Ouverture brand. It came iut very well. My settings Nozzle : 0.4 Layer heigth : 0.2 Layer Width : 0.45 Walls: 4 Top / Bottom Layers : 4 Infill: 20% Supports : Yes
Since I needed a small scoopl that would fit in my silicagel containers without dropping silica gel beads everywhere, I created this one that fits my needs perfectly. Print it face down. No support need.
Holder for the Knipex Cobra 150 pliers (model 87 01 150) for the Lidl/Parkside pegboard. My Printing Settings Nozzle : 0.4 Layer Heigth: 0.2 mm. Infill: 15% Supports: YES
Although I was inspired by this drawing of Magnus996, I drew the present model from scratch so I mark it as my original creation. It is sized to hold two Pattex glue bottles. Printing Settings: Layer height : 0.2 mm. Infill : 20% Supports…
This is the remix of the model by @Luka. I simply added numbers on the bushings to indicate the related shank diameter. Enjoy.
I found on thingiverse a fantastic knurled container fully customizable, so i made this version that fits my deburring tool. No rafts or supports are required. Try it and you'll love it. The whole thing takes about 4 hrs. to print. I used…
Deburrer holder for Lidl pegboard. My printing settings: Layer height: 0.2 mm. Infill 20% Walls: 3 at least Supports: Yes (build plate)
I love the deburrer tool handle from @jackw01.My problem was that the blades were too thick which made the clips broken. So I had to make a deep remix of the clip to fit my blades and now it works perfect. No matter with the handle…
Since I'm a runner, I have the problem to carry with me a couple of house keys without being damaged by sweat. So i found useful for this pourpose this model. I just add a ring to attach a laynard and smoothed the bottom of the case.
These are all currently available results.
