Counting matching models…
Highlights: Print time less than 20 minutes Uses only 5.5 grams of filament per object Screws in to desk using either #6 screws (M3/M3.5 equivalent) or you could use command strips for a less permanent solution Does not require supports!…
I remixed the Dino Clip with a hole for a 6mm Wide by 3mm Deep Magnet. I printed this with PLA+ for extra durability. I recommend putting some epoxy or other glue of your choice in the hole and pressing the magnet it. It should be a snug…
A simple Voronoi lid holder I designed to organize our lids for various mason jars and reused pasta jars. Despite the overhangs, this is not too hard to print provided you use PLA for good bridging performance. I created 2 sizes which can…
Summary This is a headphone holder which clamps to cymbal or drum stands. I designed this so I could hang my headphones off my Hi-Hat stand so they are always in the right spot when I sit down to practice. This model was designed to fit…
Will work for any potentiometers with the diameters listed in each filename. If you have a potentiometer with a different diameter stem leave a comment and I can upload another version.
I created a variety of sizes of mic stand cable clips. Why pay over a dollar each from the store when you can print them for pennies a piece! Tips: Print all of the sizes at first, then test them out to determine which sizes fit your…
Print as many as you can and share with your community!! I tested many different whistle designs and settled on the Flat-Pocket-Whistle-4mmFlat-Pocket-Whistle-4mm by Jonas Daehnert as the best compromise between, volume, print-ability,…
These are all currently available results.
