Counting matching models…
Remix of Spool Winder with a tighter fit of the filament guide lever to work with my remix of the Spool Holder (that supports larger filament spools). I remixed this fabulous design by Les Kaye to enable me to respool 2300g spools onto…
Quick design I made of a elf headband for an event.
Bought a new shower head and the old one had a curved handle. Didn't want to replace the existing holder to practical print to the rescue. Designed a new shower head mount. 3D printed it and didn't even have to leave my house. Can be…
Remix of Spool Holder to support larger 2300g filament spools with a maximum dimension of 300mm in diameter and 100mm wide. I remixed this fabulous design by Les Kaye to enable me to respool 2300g spools onto 750g spools. Print all the…
This is a stave silo. PRINT SETTINGS Layer height: 0.3mm Fill density: 30% Fill pattern: Adaptive Cubic Perimeters: 3 Solid layers: top 4/bottom 4 Supports: None Estimated print time: 5:20h Piece length: 180mm Pause layer filament change:…
Holder for CPAP mask to mount to a bedframe (up to 28mm in width). I needed a way to store my CPAP ResMed full face mask on the side of my bedframe instead of just having the mask resting on top of the drawer. This mount works for any any…
Kids toy for Loyal Moses Christmas Community Print Drive (CCPD) 2021. This is a stave silo in vase mode. This is a vase mode variation of the StaveSilo for faster prints and display without top of dome and hollow inside. PRINT SETTINGS…
I needed a shower head mount to hang over the edge of my bathtub so I designed one. Can be remixed if you need to fit it to the width of the edge of your bathtub.
Arlo Essential Solar Panel mount for a vertical square support post. Feed zip tie straps through the channels to mount to the support post. Slide the Outdoor Mount that is supplied with the Solar Panel into the slot. Can be used in…
Holder for CPAP mask to mount onto a handle of IKEA Helmer drawer or a handle of similar size. I needed a way to store my CPAP ResMed full face mask on one of the handles of a IKEA Helmer drawer instead of just having the mask resting on…
One of my first designs which was a mount for sunblind crank. Since this was an early design and can be improved to make it more 3D printable I welcome remixes of this. But this worked fine for my application when my old mounts broke. Be…
Arlo Ultra 2 balcony mount with solar panel slot. This certainly is not a fast print since it was a specific use case and a early design of mine but it works flawless. Use the camera mount that is supplied with your Arlo Ultra 2 mount and…
A quick design I made for my IKEA SKRUBB basket to separate larger from smaller pieces of failed prints. Can easily be adapted to other basket sizes.
These are all currently available results.
