All models

Counting matching models…

PrintablesPichurin_ae

Flexible cable channel for Reborn 2

Flexible cable channel for Reborn 2 v1

Downloads: 173
Likes: 23
Rating: 0

Order a print of this model

PrintablesPichurin_ae

Voron 2.4 Roller Bearing Type Spool Holder. Long EndCap

I increased the height of the lid to prevent the spools from flying off when printing.

Downloads: 81
Likes: 11
Rating: 5

Order a print of this model

PrintablesPichurin_ae

Faketec nRF MeshCore \ Meshtastic

Housing for nRF. Inside there is a 3000mAh battery, a Facetec board, and a power switch. There is also a place for GPS and peripherals.

Downloads: 44
Likes: 7
Rating: 0

Order a print of this model

PrintablesPichurin_ae

Voron 2.4 HEPA Filter

Voron 2.4 HEPA Filter with fan channel. I added a duct to run the wire from the fan for the indoor installation.

Downloads: 40
Likes: 11
Rating: 0

Order a print of this model

PrintablesPichurin_ae

7" KlipperScreen for Reborn 2

Downloads: 35
Likes: 6
Rating: 0

Order a print of this model

PrintablesPichurin_ae

QuickDraw (Klicky) Servo Dock

it was designed for installation on Reborn 2

Downloads: 31
Likes: 4
Rating: 0

Order a print of this model

PrintablesPichurin_ae

This model is a control box, includes: - Two places for power supplies with a size of 58x85x32mm. - Three landing pads for the MOSFET. - Raspberry pi or Orange pi pad - Installation location of the 220V solid-state relay the cover…

Downloads: 28
Likes: 3
Rating: 0

Order a print of this model

PrintablesPichurin_ae

Foldable spool holder

Folding holder for a filament spool with two tubes

Downloads: 16
Likes: 3
Rating: 0

Order a print of this model

PrintablesPichurin_ae

QuattroBox JST HX2.54 canbus

connector canbus for JST HX2.54

Downloads: 11
Likes: 3
Rating: 0

Order a print of this model

PrintablesPichurin_ae

QuattroBox JST+MX canbus

connector canbus for JST HX2.54 and MX3.0-SM

Downloads: 7
Likes: 1
Rating: 0

Order a print of this model

PrintablesPichurin_ae

Aquastop

The case is designed for ESP32 C3 supermini on the legs and on the expansion board. You can also use any ESP board suitable for the form factor. Wemos D1 mounting holes have also been added. The button holes have a diameter of 13mm, for…

Downloads: 5
Likes: 1
Rating: 0

Order a print of this model

These are all currently available results.