Counting matching models…
Okay this is pretty simple, I had the hatch fly off on my ranger, luckily it was on launch. I decided that I was not overly enthused with the clip nature of the original system. I printed at .1mm height. I used organic supports to support…
Print these with at least 3 walls and 3 top and bottom layers. Print one bottom and 3 sections. There is an OD taper on the section which goes down, I suggest you use a brim to help keep it on the bed. After printing glue the sections…
This is for the HDZero Micro sized camera. There are quite a few different pan setups out there for the ranger but all seem quite bulky and large so I designed this light weight and compact system. The prints are out of PETG and the belt…
I printed mine at .1mm and put the cover on its back. I used 3mm heat sets for holding the cover on with some 3x4mm cap srews. Thanks and suggestions are welcome!
This little guy slides in between the GPU and the fans to stop the GPU fans from hitting the bottom fans. The two little pegs drop into the fans so it cant move or shift around after it is slid in. Print with the little pegs up. Just…
These are all currently available results.
