Counting matching models…
Gopro mount for the fork of a dirt bike. Made specifically to fit a wr450f, but would likely fit almost any bike with the same fork diameter (59.5 mm or so). Use m5 bolts to clamp it down, and the m5 bolt that comes with the gopro to…
This Jig centers a candle wick in a 32 oz mason jar, or other jar approximately 3-3/8" diameter. Can be scaled up or down as well to fit other sized containers. Used when pouring home made candles into jars.
Spacer for the fuel rail on a 4g63 engine. Print in material that will hold up to being in an engine bay! Category: Automotive
This is a replacement plug for the dash of a second gen Nissan Frontier, which will remove the aux plug and replace it with usb. The usb cable used came with a Pioneer head unit, in order to run android auto. This part fits in exactly as…
Adjustable z endstop system for the Foglertech FT-5 printer. I have the r1, but I imagine this would fit on the r2 as well. This eliminates the need to physically move the entire endstop up and down when trying to dial in the z endstop.…
Solid Y end-stops for the Folgertech FT5. These are meant for use with sensorless homing (like on the TMC2209 drivers), and give the bearings something solid to run into. I had issues with my two y motors getting out of alignment with a…
I was tired of how the end stops worked on my folgertech prusa i3 2020, so I came up with this little piece to help out. Instead of having to move the whole end stop on the z axis up or down slightly through many trial and error attempts…
This is a simple mount to connect a BigTreeTech TFT35 v2 to the Folgertech FT-5 printer. It mounts in the same location and with the same hardware as the original LCD display that comes with these printers. The hole on the right of the…
This is a simple carriage for the Folgertech FT5 printer. Designed for the v1 printer, but I imagine it would work fine for the v2 as well. This is meant specifically for a Bondtech BMG extruder or clone, and turns the whole setup…
This simple mount holds the generic LCD panel to the top of the right z-axis motor. You will need a little longer m3 bolts for the stepper motors, and you will need 3 fairly short m3 bolts to mount the 2004 LCD plate itself to the mount.…
These are all currently available results.
