Counting matching models…
This model replaces the original mudguard with the integrated chainguard. Just removing the OEM one doesn't do the trick, as oil/grease/dirt from the chain will be yeeted everywhere. With this chainguard the back not only looks cleaner,…
Printable without supports, this strong hook is ideal for stowing away a heavy bag or backpack under an IKEA Bekant desk while still keeping clear of the floor. The hook is mounted with the two original hex-bolts on the side of the…
This is a snug fit for the Clarett/Clarett+ 2Pre (including its rubber feet) and the latches hold the interface firmly in place. So it's no problem to plug in/out an XLR cable with one hand. Yet, after disconnecting the cables on the…
With the hopes of gaining some practical knowledge and experience with a VAWT, this scaled down turbine's purpose is to trial and error. No supports are needed and the blades print in spiral mode. The axis has a diameter of 6mm and is…
My interpretation of a lens hood and 77mm filter adapter for the Canon Lens EF 50 1:1.8 II, complete with lens cap. The lens cap is optional, as the original cap will fit into the hood as well. Slicing make sure layer height is suitable…
Replacement sensor holders for my “ Gardena Clear Water Submersible Pump 9000 aquasensor ” water pump. These parts replace the original holders, housing the “ON” and “OFF” sensors (#6 in spare parts list). Printed in ASA at 0.4mm layer…
Replacement for the "Giacomini R450X001" valve regulator for radiators (mount and knob). The mount tightly snaps onto the radiator, softening the print with some heat helps. Both knob and mount have been updated with thicker walls, since…
These are all currently available results.
