Counting matching models…
Based my design off of Jok's. Increased the size to accommodate fitting onto a 6" (150mm) exhaust fan and 6" exhaust duct made from standard HVAC sheetmetal parts. Also added magnets to the housing and gate to allow it to stay fully open…
A simple miter / crosscut guide for a hobby saw that uses 2x 8mm x 2mm magnets to hold the sawblade in alignment. You need to print one guide and 2 fences to make the tool. The fences are held on with M3x12mm button head screws with hex…
Small 90 degree clamping block for spring clamps, used to align ribs while building balsa RC plane wings or other smaller items. Clamp is 1.25" square and 0.5" high. The small round pad it perfect for a fingertip to hold the clamp in…
Simple tool to help set a ¼" reveal on a door frame with wood molding. Similar to the “Trim Buddy” Also has 45 degree angle to mark your miter cuts. Printed with 4 perimeters and 50% infill but this can be reduced to 25%.
Added filets to the inside corners for a small amount of added strength and removed the hole to hold the cord. Printed in PETg with 0.30 layer height.
Panel mount for XT60H-M connector. This variant was used on material that was ~ 0.625" / 15.875mm thick. Plug is a tight friction fit, installed from the back. The inner plate has just enough protruding to locate it in the hole and hold…
Simple 2" High laptop riser for 15" laptop with wide feet to help prevent it from rocking over. Printed on Mk3 with PLA, 0.3 layer height, 4 walls, 25% cubic infill. Printed a previous version at 0.2mm but it doesn't really need that…
Thin, simple tabbed dividers for a 3 ring A5 notebook (5.83 x 8.27 inches) . I printed with (0) top layers and a honeycomb infill just for visual appeal. PLA is sturdy enough yet flexible to not interfere with turning pages in the binder.…
Small wrench to tighten the switch nuts on FrSky Transmitters. Wire used is 0.03 music wire. I had to clean out the holes with a drill slightly smaller than the wire, then pressed them into the holes. For the print, I used 0.30 layer…
These are all currently available results.
