Counting matching models…
Vatuhiva has modelled an extruder body where a BL-touch can be mounted to the R4 extruder, but i happend to print the R6 version. So i chopped of the original sensor mount and added a snippet of his design so it would fit for sure with…
Made a few modifications to the Carriage created by RoboMagnus. made the slot for the Belt 0.2mm wider -> fits better with my aftermarket GT2 belts. made all the Inserts for the square nuts higher, so i could put regular M3 nuts in there.…
I wanted a 45 degree piece, so i chopped and stitched the original file accordingly.
4xM3 screw mounts + 2xM5 screw mounts
Another alternative design of the X axis carriage for the Anet A6 printer. This one is focused on minimal space occupation and support free printing. Diverse M3 and four M4 screws plus matching nuts are required for the assembly. The…
Speaker adapter for Peugeot 308 SWII to JBL Club 6500C and JBL Club 622. It fits the front and the rear door. I did print mine in ABS+ and seal them against the door with 2mm foam rubber. The backside has holes for four standart M3…
In case you don't want to mess with sensorless homing you can clip this part onto the upper smooth rod and mount a Makerbot endstop to it. Works alright on my printer.
Reverse engineered from the factory tweeter mechanism. Tested and fitted in a Peugeot 308 SWII with the JBL tweeters, but it is probably compatible with other Peugeot models as well. The back has holes for three standart M3 heatset…
Adjusted the design to accept m3 screws and nuts + removed some material. This is a remix from this design: https://www.thingiverse.com/thing:4659115
Remix to fit another endstop switch from Makerbot. I use it with the anti woble X-Axis. I also adjusted the piece which mounts to the printer slightly, so it would have less overhangs and print a bit smoother. This is a remix from this…
I Adjusted the hinges to mount Cimalpacino's Ramps enclosure to my Bearmod Scratchbuild made out of regular I-Type 20x40 T-Slot profiles. Just in case someone else cheaped out on the extrusions. Mounted mine with M4x8mm Screws.
Just a generic army tray for the warhammer figurines with a 20mmx20mm base
Mounting bracket for the voron stealthburner to mount the SHT36 V3 can bus toolhead board in the bowden configuration. I also adjusted the cable cover. I have it installed on a voron legacy, but i think it shoud be compatible with other…
Quick and sloppy remix to fit the 40mm fan that came with my DLC kit. Check out the model from Fintech for the rest of the box ( https://www.thingiverse.com/thing:4680702 ). Freecad included, in Case someone wants to tinker with it. This…
simple rack mount for odroid n2+
The stock fan was too loud for my liking, so I replaced it with a 120mm PC fan. to allow for sufficient airflow those feet will lift the printer 35mm + 5mm if you add some cork underneath it. I attached them with hotglue.
A blank plate to cover empty slots on a 19" DAP Rack mount
These are all currently available results.
