Counting matching models…
I needed a Christmas present idea for my Brother-in-Law who is a utility contractor. After searching for a seat hook for the Toyota Tundra, the only option that I could find was @scarrson's design for the Tacoma. After some trial and…
Since the included CAN Cable for the EBB36 Gen 2 lacks stiffness, I added a PUG connector to the retention arm to allow me to use a braided sleeve and a steel wire with a PUG strain relief to onewordFOURWORDS' mount. The PUG itself was…
I needed a comparable version of the Center Rear Stealth Skirt for my Changer build so I did some slicing and dicing in Orca Slicer to get one. I hope that this is helpful for anyone else that wants to take this pathway.
Most if not all of my current drybox cups use a PC6 or PC4 screw in connector which causes the filament to drag on the brass from the back side as it is being fed into my PTFE tubes. This should remove that induced drag from the equation.
These are all currently available results.
