Counting matching models…
Recommended to me by a dental hygienist many years ago, just run one of these over your tongue to scrape away bacteria that lead to bad breath. (Don't forget to brush and floss too). Only takes 34 minutes to print at 0.2mm layer height…
Can crusher for 355 ml (12 fl oz) aluminum cans. Also works for 221 ml (7.5 fl oz) cans. Made with a bottom that centers the can. Also, there are drain holes (so make sure your can is empty) to aid in cleaning and poking the can back out…
Cover for the mount side of Nikon lenses. Tested with: AF-S NIKKOR 16-80mm 1:2.8-4E ED NIKKOR-S Auto 1:1.4 f=50mm NIKKOR-Q Auto 1:3.5 f=135mm Rokinon 1:1.4/85mm AS IF UMC Designed in FreeCAD Print instructions Print with the open side up.…
I noticed that many of the current Raspberry Pi 4 fan cases placed the fan directly over the CPU. While that is nice in theory, it prevented having an RTC. This design tries to keep a low(ish) profile while allowing for a heatsink and…
This is a paper towel holder meant for the Gladiator storage system / slatwall. It keeps your paper towels off of your workbench and within reach. I used a 5/8" dowel to provide additional stability for holding the paper towels. So, I…
The watchband tail retainer broke on my Vivosmart 3. Again. Garmin was kind enough in the past to provide a replacement, but this watch is discontinued. Rather than pay $6 for 5 replacements off Amazon, I designed this. Printed with…
This is a case for a Wifi & GPS device meant for Celestron telescope mounts at have available AUX ports. It combines the features of a few commercially available dongles into one device. The full project discussion can be found at…
An updated, more compact version is available here: https://www.prusaprinters.org/prints/67382-homebrew-wifibluetooth-gps-accessory-for-aux-bus-c Original: This is a case for a Wifi + GPS + ESP32 project used to connect to Celestron…
The watchband tail retainer broke on my daughter's Forerunner 215. I started with my other Vivosmart retainer , made new measurements, and printed this off. Printed with Ninjaflex Sapphire TPU for some flexibility, 0.25mm layer height,…
Printed at 0.2mm layer height. I used ABS-T (Filament PM) and CF-PETG (Atomic Filament), but regular ABS/ASA or PETG should be fine for strength. I wouldn't recommend PLA. Print with the long, flat side down, and use tree supports to help…
These are all currently available results.
