Counting matching models…
iPad stand with a slot for the charge cable and recesses for rubber pad feet. Print Settings Printer Brand: Creality Printer: Ender 3 Pro Rafts: No Supports: Yes Resolution: 0.2 Infill: 30% Filament: Any decent brand PLA, PETG Black…
A 3 shelf spice (or any other purpose). This is 300 mm wide (just under 12") and each shelf is 60 mm deep (about 2 ½") and each tier is 50mm (just under 2") higher than the one in front. Has mass reduction on the middle support wall, back…
I made this to prevent me from spilling oil when I change oil in my Altima. This should work on any late model Nissan. I've used it once and it works without any seeping out even without a gasket. Threads have a slightly loose fit by…
This is a tool to be used on oil filter covers that have a 24, 32 or 36mm hex drive. This style oil filter cover is used on many newer cars. Chevrolet, GM and others use the 24mm style. Designed to work with a 3/8" drive then turn by hand…
There are many many food dehydrators on the market that are basically clones of the commercial chef model that this model is based on. Any food dehydrator with a 9-5/16" (233mm) inside diameter tray base will work. Print with the smaller…
Stand, sound reflector for iPhone 7 or SE in a Otterbox Defender case. Turns sound towards the front of the phone. Serves as a stand either standing upright or laying on its side. Print Settings Printer Brand: Creality Printer: Ender 3…
Use this to attach to a wall or to generic DIN rail mounts (available on Amzon, eBay, AliExpress etc) Has access hole for DIN rail clip release. Integral spacers keep upright when DIN rail mounted and spaced away from the wall when wall…
Tube Stand for non standing toothpaste tubes. Tested and works on 6oz size Colgate, should work for others Print Settings Printer Brand: Creality Printer: Ender 3 Rafts: No Supports: No Resolution: 0.2 Infill: 20% Filament: Any decent…
These clip into the face shield mount receptacles on many hard hats and can be used hold the loops on face masks and spare your ears. This works for the 30mm by 3mm by 17-18mm deep receptacles on the hats at my work. Check your first to…
Should print fine with the drain holes down on the print bed (that should have the best surface finish on the top). Any PLA or PETG should work fine.
This allows you to hang up two sets of keys. Category: Organization
These are all currently available results.
