Counting matching models…
Mod of the original slimbox. It's a ergonomic hitbox-style layout low profile fightstick. It's specifically designed for Street Fighter 6, where using parry and drive impact is crucial. Therefore the usual 2 rightmost buttons got…
Print 2 hooks. Print the router mount with supports. Assemble. Mount. Easy. 0.3mm layer height is good enough.
Added 2x 120mm fans to the bottom of an old Vobis Highscreen PC case. Had to print new 3cm feet to get some air flow going. Used feet for a Lenovo T5 as inspiration and as a base model.
Print on the side, use PETG, enable organic supports on print plate only. Enjoy.
Print standing up and enable organic supports + print on bed only.
From the original model: This is a very simple adapter which allows to replace the original very cumbersome phone holder from the Ikea LÅNESPELARE with a MagSafe Puck. The puck fits very tight and is hard to remove after putting the puck…
Parts needed: Ikea Vattenkar monitor stand arcade buttons of your choice a controller board like a gp2040-ce breakout board or a brook fighting board wiring forstner drill for the holes and a few screws to mount the side panels glow in…
These are all currently available results.
