Counting matching models…
Small window exhaust port for my resin printer to pop out the very small window I have. I unfortunately feel like I really need a sla printer to get the quality I want for my mold making, so here we are. Resin is gross.
A 90 degree connector for an extraction fan to allow me to better vent out nasty resin, airbrush, or solder fumes. you might need to use an elastic band to “seal” the elbow onto the extraction fan. See gcode for an example of the…
100mm to 75mm magnetic attachment for Airbrush Booth, with the idea that the connector from @Ghengisahn's model can be used not just for venting those gnarly resin fumes, but also other purposes. You will need a 75mm duct and extraction…
Easy breezy, made for a reddit person who lost their clip. Recommend PETG as the material, since the circular part/omega symbol is meant to flex a bit to accommodate inserting a cable. The top might need a bit of sanding depending on…
A hangable 3D scanner based on the kinect, arduino, and a stepper motor. Not working yet, but figured I'd put it up so I could get critiques and suggestions as I work. The code base is currently in progress, will be borrowing heavily from…
Lose your config block? Here's an easy model to print and configure your opentrons OT-2. This is used to configure the z axis of the ot2 pipettes. Infil: 5% PLA or PetG
Top and bottom STLs for a baby groot helmet for my toddler. I printed in petg and the draft preset, and used smart supports for the top. 10% infill Note: the edges are a bit sharp, so recommend heating w/ lighter and going over a bit with…
Small 1.5cm offset piece for a cheap Amazon keyboard tray slider to facilitate a synthesizer. Basically lowers The tray a bit to accommodate the knobs I swore would fit when I measured everything initially. Nothing special. You will need…
These are all currently available results.
