Counting matching models…
My most popular design on Thingiverse - Now on Printables! These stands are designed to hold the Original Gameboy, Gameboy Pocket and Gameboy Color. The small pin goes into the headphone hole on the Gameboy and prevents them from falling…
This is a single piece BIQU H2 extruder mount to fit the EVA 2.4 system for the updated Mercury 1.1. The mount has been designed to keep the extruder firmly in place and prevent rotation when moving fast in the X and Y axis. There is a…
This is a mount for the BIQU MicroProbe made to fit the Mercury One.1 ZeroG mod. It uses the short screws and nuts that comes with the probe to mount it. The probe offsets are as follows: x_offset: -35.5 y_offset: 5.0 z_offset: 1.390 Z…
A set of RCA protector caps that holds itself onto RCA plugs. If the cap is too large or too tight with your printer, simply scale it up or down until it fits. It is designed with a 0.1mm error margin. so it should work out of the box in…
This is a modified modular spool holder shaft for the FormFutura Modular Spool Holder to fit eSUNs 5KG spools with a 30mm opening. The shaft is 28mm in diameter so it will fit other spools with a 30mm center hole. Due to the size of the…
Cross bar braces for the Creality Ender 5 Plus to stiffen up the frame a bit and lessen the top wobble caused by X and Y axis movement. It reduced the visible wobble quite a lot on my printer. Use any 8mm rod cut to 670mm +/- 5mm for the…
This is a replacement part for the plastic adapter mounted on the end of the diaphragm shaft that connects to the lever control arm for the throttle shaft for Suzuki Vitara XL-7 first generation. This replacement part goes on the end of…
This is a simple cold shoe mount you can attach to a wall, table, bed frame or anything else you can drive a screw into. It's secured by two countersunk screws and can be mounted on any wall or surface. Any regular 18x18mm shoe will fit…
This is a remix of Smokebeast's remix with pre-cut holes if you don't want to mess around with infill and top layer customization.
A simple back cover for the timed relays from Wolsen Tech
I've made a spacer for the SVS PC-13 amplifier upgrade. It has been test fit with the original Bash amplifier and the Sledge 1200D in my 13 Ultra. The height is 10mm but it can be scaled to fit your specific subwoofer needs. Be sure to…
These are all currently available results.
