All models

Counting matching models…

Holder for large multimeter / VoltCraft VC 850 V2

make sure to print with lots of support, try to not support the part that clips in, this adds a lot of material to remove after and can make the fit a little too tight

Downloads: 59
Likes: 13
Rating: 0

Order a print of this model

PrintablesThat One Twat

Holder for Dremel tool stand (HoneyComb) (as pointed out by @MarioVerdejo_1234412 this print is 90 Degrees the wrong way)

Dremel tool stand Holder remel XS17 – 2222 Flex Shaft tool holder for Dremel XS17 Dremel 225 flexible shaft tool holder the top/front/1st cut is slightly smaller to accommodate the smaller middle pipe that has a taper on each end

Downloads: 18
Likes: 4
Rating: 0

Order a print of this model

These are all currently available results.