P
PrintablesEccentricToast
Wago Snaplock box
Used Hugos Snaplock box because I love the fact it requires no hardware or filament tolerances. This will hold 3 set of the 50 piece collections from Wago.
- Downloads
- 1,962
- Likes
- 448
- Rating
- 5
All models
Counting matching models…
P
PrintablesEccentricToast
iPad Mini 4 Slide Wall Mount
This is my iPad Mini 4 wall mount to use home assistant. Its a slide system so you can take the ipad and use it like normal. This is the 90 degree cable i used.…
- Downloads
- 719
- Likes
- 44
- Rating
- 4.5
P
PrintablesEccentricToast
Xbox One/Series X/S Controller Dock
I have the microsoft charging pack for my Series X controller and needed a dock that would hold and charge it and this is what I came up with. I used the amazon basic usb-c cables and they needed a little jamming to stay in place. Print…
- Downloads
- 334
- Likes
- 50
- Rating
- 5
P
PrintablesEccentricToast
Samsung Tab A7 Slide Wall Mount (T-500)
I needed a wall mounted tablet for home assistant but I didn't want to have it permanently fixed to it so that I could take the tablet away quick and easy to use the tablet. I used an m4 bolt with the head cut off to hold the two halfs…
- Downloads
- 214
- Likes
- 22
- Rating
- 5
P
PrintablesEccentricToast
S22 Ultra F10/F11 BMW Cupholder with Spigen Case
This is a redesign of my original Note 20 Ultra phone holder with a tough armor spigen case to accomodate my new phone the Samsung S22 ultra with the same case. I have made the design with a lower height and overall smaller frame. For my…
- Downloads
- 194
- Likes
- 20
- Rating
- 0
P
PrintablesEccentricToast
F10/11 Phone Holder (Note 20 Ultra with Spigen case)
I designed this for my right hand drive F10/F11 to hold and charge my Note 20 Ultra with a spigen case. Added off-centre ones because they come very close to the centre console trim also added an off-centre LHD version Uploaded a shorter…
- Downloads
- 121
- Likes
- 11
- Rating
- 5
P
PrintablesEccentricToast
MK4/MK4S X Motor Cover & Cable Protection
Created this remix as I wanted to have the motor completely covered as I always feel it looks a bit incompete and added the cable protection while I was at it! I printed this with an MMU3 at 0.2mm face down using organic supports. I added…
- Downloads
- 75
- Likes
- 18
- Rating
- 5
P
PrintablesEccentricToast
C920 Front Facing (Articulating Mount)
This is my remix of RedKB's front mount for the C920. I had previously been using the Pi camera with Sneaks articulating mount and really liked it. When I upgraded to the C920 I didn't like the big bulky mount so I used Nat's mount to…
- Downloads
- 51
- Likes
- 8
- Rating
- 0
These are all currently available results.