Counting matching models…
The original Gridfinity base by Pey fits in a 7x12 grid into Ikea Alex drawers. In total the original design measured 297mm x 525mm. However, my Alex drawers measure 295mm x 523mm . There are lots of comments about the original's fitment,…
2x PG7 AB Motor Plate for CAN bus with PG7 umbilical and PG7 gland. Remixed - added cable recess (RGB / USB)
I needed to fit 10mm Pogo connectors to THE FILTER's standard mounts, which were originally designed for an all-in one Pogo cable. Might require a drop of CA glue. Pogo magnets are super strong! Cheap 10mm Pogo connectors from AliExpress:…
I needed a flat edged cable clip for 2020 extrusions on a Voron 2.4. I found the original design by shadokyn but needed something which let me remove the panels without removing the clips. A few minutes later, this remix was born.
I needed a rear-mount ZeroClick for my Voron 0.2r1. I couldn't use the centre-mount due to MFNano taking up the space under the rear gantry. However, when I used the stock rear-mount I lost lots of Y-travel. I modified the ZeroClick rear…
These are all currently available results.
