Counting matching models…
I added a vice block to werz 99's soldering jig. The cross profile indexes with HD_Creator's mini vice found here . The photo shown above is of the prototype and the file uploaded should index better since I moved the cross .5mm lower.
This bracket uses the hardware included with the camera. Bracket attaches to the wall using 3x medium 3M Command Strips. Printed with 20% infill.
Adapted Eltord's LTT Screwdriver Hanger to work with Sy's Peglock. Requires "Board Attachment (Universal)" from “Sy's Peglock - Locking Pegboard System.”
Remember to remove the support material from where the Command Strips go.
I made this for the needle nose pliers that came with the Prusa MK4. This model relies on the spring force of the pliers to stay in place. I wanted something like…
Replacement PVS-14 ocular lens cap. Only tested using flexible filament so you might run into issues with fitment if you use a rigid plastic. There is more than enough clearance to have a demist shield installed.
Designed to hold Woolite dryer balls. Mounts to the wall using medium Command Strips. Printed with 10% infill and .2 mm layer height. No supports needed.
Print in TPU. The iris was purchased from Cold Harbour Supply and has a outer diameter of 45mm. You can use the cap without the lens protector but it will overhang a little bit. There is two versions of the model. There is a solid cap and…
These are all currently available results.
