3 models
This stand can hold 5 classic disposable razors. Foam spray fits In the middle. Print the large Base part in vase mode, the connector ring and the crown can be printed normally without support. The connector ring and the crown has tight…
Print approx. €0.50–€0.61 excl. taxPreliminary estimate for one variant
Non-jamming filament sensor housing. Fits the original switch, just replace the plastic case. Tight fit, no screw or glue required. Push the PTFE tube about 5mm into the hole at the top. May fit to other printers, but the mounting holes…
For 5mm outer diameter bowden tube, but easy to modify to fit any size Additional hardware: 5x5mm (h/d) cylinder magnet x 3 Layer Height: 0.2mm Speed: 200 mm/s Infill: 10% gyroid Filament: 4g / 1.5 m Printing Time: 17 mins
These are all currently available results.
