Counting matching models…
☕ The original Nespresso Vertuo Pop drip tray was too small in diameter and too high to fit my Starbucks “You are here” mugs meaning we had to use it with the drip tray removed and that left drips on the kitchen countertop, or we had to…
❤Heart shaped❤ floss drops/Thread holders. Designed in part by my wife to her specifications. There is a large hole toward the tip of the heart to allow for large amounts of DMC thread to be looped through. The two smaller holes are for…
I got some Unifi AC Mesh access points from an office refresh however I wasn't able to get the wall mount kits with them. Able to be used to ceiling or wall mount the access points, Screw slots added to allow some adjustability.
I have installed a Hue smart lighting system throughout my home however I have not wanted to completely remove the existing light switches and I still want to maintain occasional access to the switches in order to reset bulbs.The main…
I took a lot of inspiration (copied) Bitterbuffalo's design (Thingiverse) as it worked so well for my iPhone XS and re created it for an iPhone 11 (at time of posting I have not printed and tested so sizing may be off). Print instructions…
Does your office chair sink to the ground while you sit on it? this is a brace designed to fit round the chair lift. This stops it retracting and you ending up stupidly close tot he floor. Attaches with Zip-ties or tape wrapped round it…
This is a magnetic frame designed for the small Mill Hill ornament kits to preserve both your hands and the perforated paper. It keeps the perforated paper in great condition while also allowing you to hold it more easily or mound the…
I put a CAT6 cable out the back of my house and needed a cable grommet I could attach a UV cable shield to (I don't like the idea of CAT6 in the sun). Found and remixed an existing cable grommet to add a section of pipe at a 90 degree…
Inner diameter 20mm, outer base diameter 30mm, top diameter 25mm, height 5mm. Designed to stop my Samsung washing machine being turned on while working in the kitchen as I passed by. Printed in PLA as there is not a need for anything…
Holds 4 9v batteries. This should not need supports the circle (cheese holes) should print without it. I made this based on 9v sizes off the internet as I don't have a spare currently to measure, both a downloaded 3d model and the googled…
This is a quick replacement for the plastic portion of a Lowery magnetic board attachment used on my wife's cross stitch stand. The stand itself is very solid however she wanted a more fun colour for the magnetic board holder. I also plan…
These are all currently available results.
