Counting matching models…
Various Organizers compatible with Drakka01's original designs. Food inventory can be stored in the top and bottom sections. The center section holds the player pieces and has numbers at the bottom to indicate the number of turns left.…
Simple stand to hold your Nintendo Switch Dock in a horizontal position. I listed two version - one with the logo and one without.
Cases for holding your rolls of 35mm film. Models available in 1x4 and 2x3 variants. Models use 6mmx3mm magnets. The 2x3 variant has spots for 6 magnets but you can get away with only using 4 of the spaces and it will still hold fine.
2x5 roll 35mm film case with slots for film tabs. Uses 18 x 6x3mm magnets.
Stand for Polaroid i600 photos. Can be printed without supports.
Stackable case for a Pentax 110 and its standard lenses. Uses 12 x 6x3mm magnets.
A simple two column dispenser I use to hold my Lactase pill packet. Print upright and enable supports everywhere. There should only be supports in the dispensing slot to hold up the wall overhangs.
A slightly over-engineering laptop stand that will require 24 x M3x10 bolts and hex nuts. You will need to print: 2 x Side Braces 1 x Top Brace 1 x Back Brace 1 x Bottom Stringers (STL contains the two stringers you will need)
These are all currently available results.
