Counting matching models…
This is my newest battery bank using 25 Telsa 21700 5amp cells. This is updated with cable channels added for easier cable management! Heat Shrink tubing application. https://www.youtube.com/watch?v=gLj-ytjKPAI&t=18s
Print approx. €2.99–€3.66 excl. taxPreliminary estimate for one variant
My version of a gyro spinner. Use all supports when printing too. 2, 608-spinner bearings 1, 4x50mm bolt 1, 4x70mm bolt 2, 4mm locking nut 3, 3/4" Stainless Steele Nuts from Ace Hardware
Print approx. €0.39–€0.48 excl. taxPreliminary estimate for PETGSource material: PET
My Best Six Million Dollar Man Plate. Variable layer height also required uses two layers.
Print approx. €7.71–€9.43 excl. taxPreliminary estimate for one variant
The Six Million Dollar Man Logo, Dual Layer with variable layer height base.20mm & text.10mm. ENJOY!
Print approx. €5.85–€7.15 excl. taxPreliminary estimate for one variant
This is my first lithophane model of the Bat Masterson logo. This print has two layers a base and letters on the second layer.
Print approx. €3.56–€4.35 excl. taxPreliminary estimate for one variant
This is my first design 30, 18560 cell power bank. The top and bottom plates are designed for parallel cell connection. Works great! ENJOY! Print instructions No supports required cells fit nice into holders looks great when assembled and…
My medium display shelf. I use a 1" sheet rock screw to mount shelf.
This tool allows safe and easy insertion of the bearings into a fidget spinner. Bearing insertion force is only applied to the outer bearing race.
I used supports under the model only, attached to the floor with a 1" sheet rock screw. !!ENJOY!!
This is the ALTN Pitch Trim Lever for the PMDG 777-300ER MSFS 2020. Made for the Thrustmaster Bravo Throttle Quadrant. Fits great works great, enjoy.
This is my tag i use on my drone, looks and works great. Printed in two halves and glued together. Us velcro straps to attach. ENJOY! Print instructions This is the tag i use on my drone, looks and works great. Printed in two halves and…
My version of a gyro spinner. Print this orientation support everywhere! Use all supports when printing too. 2, 608 Ceramic 8x22x7mm-spinner bearings 608 Ceramic Fidget Spinner Bearing 8x22x7mm – ACER Racing Hardware Below Obtained from…
This is a shelf from my antique oil lamp. Use supports all, will print great and looks great too!
The Six Million Dollar Man Head Eye Side View. Dual layer design.
These side brackets are for my Venezuelan red tail boa to have something to climb on in her tote! I use bamboo for Snips to climb on so far so good. .30-layer height and 150% print speed. I used a solder iron to burn holes through the tub…
These are all currently available results.
