P
PrintablesTravisT
Zipper Pull
Printed with 95a TPU
- Downloads
- 57
- Likes
- 5
- Rating
- 5
All models
Counting matching models…
P
PrintablesTravisT
Multiboard @KeepMaking Olfa Knife Holder
This is a simple Multiboard @KeepMaking press fit mount I designed to hold a retractable Olfa knife. I hope it can help anyone who can benefit from it. Works great.
- Downloads
- 33
- Likes
- 5
- Rating
- 0
P
PrintablesTravisT
Metamucil Scoop Small
I hope others can benefit from this. This is my first design using OnShape. I think it looks pretty good and it prints well. This version will measure out a little bit less than 1 tablespoon. Printed using inland PLA+ (FYI - Not…
- Downloads
- 15
- Likes
- 1
- Rating
- 0
P
PrintablesTravisT
Short Zipper Pull - Billy Shoes
This is a short zipper pull designed for Billy Shoes that have zippers to close them. Or any zipper for that matter. The hole in the zipper pull is big enough for a single finger to grab it with. A little difficult to install, but not…
- Downloads
- 12
- Likes
- 1
- Rating
- 0
P
PrintablesTravisT
Netipot Lid
Recently broke my Neti Pot lid. Designed a new one. Enjoy!
- Downloads
- 8
- Likes
- 1
- Rating
- 0
P
PrintablesTravisT
SRAM MULTICLIC DUAL AND SINGLE MOUNTS
Designed SRAM MultiClic mounts to accommodate both buttons on the same mount due to having limited mobility with one hand. Also including a single button mount. You will most likely need 2 different cable length MultiClic buttons to run…
- Downloads
- 1
- Likes
- 2
- Rating
- 0
These are all currently available results.