P
PrintablesCozmogeek
Painter Pole Mount
This uses m3 sized screws to mount. The internal threads are for a painter's pole..
- Downloads
- 52
- Likes
- 9
- Rating
- 0
All models
Counting matching models…
P
PrintablesCozmogeek
BaoBao Double Baofeng ht radio mount for Arrow Yagi Antenna
To install this you will need to remove the foam handle, which can be done by pushing from one end and pulling from the other. Eventually it will slide off. Remove the 2 rear antenna elements and slide the mount on, then reattach the…
- Downloads
- 34
- Likes
- 4
- Rating
- 0
P
PrintablesCozmogeek
6m Moxon Antenna for a painters pole
This design was built to use fiberglass fence posts such as electric fence poles. They are around 9.75mm diameter and can be purchased from stores such as Tractor Supply for about $2.50 each. You may need to scale the parts up or down to…
- Downloads
- 32
- Likes
- 5
- Rating
- 0
P
PrintablesCozmogeek
70cm QFH Antenna
This antenna is a work in progress for me. Your results may vary. All dimensions from https://jcoppens.com/ant/qfh/calc.en.php This is designed for 3mm wire (14awg). I made the mistake of using THHN wire for the one in the image, which…
- Downloads
- 29
- Likes
- 11
- Rating
- 0
P
PrintablesCozmogeek
UHF Eggbeater Antenna
This eggbeater antenna design uses 1/2" x 1/8" aluminum that you can find at Home Depot or similar stores. It is designed for the UHF satellite band (~437mhz). The mesh for the reflector is optional but is supposed to improve performance.…
- Downloads
- 15
- Likes
- 2
- Rating
- 0
P
PrintablesCozmogeek
uputronics Filtered LNA outdoor enclosure
these filtered LNA devices are more effective if they're on the antenna side of your feed line.. but the uputronics devices are not suited to be outside so I designed this simple enclosure. Printed in ASA for maximum UV protection. It…
- Downloads
- 7
- Likes
- 0
- Rating
- 0
P
PrintablesCozmogeek
K7ZOO Parasitic Lindenblad Antenna Caps
The rest of the antenna parts and plans are here: https://www.thingiverse.com/thing:4626749 This is just the end caps so you can print them yourself in TPU instead of ordering more parts. You will need 8 of the .375" caps and 1 of the…
- Downloads
- 5
- Likes
- 0
- Rating
- 0
P
PrintablesCozmogeek
Arrow Yagi TPU belly rest
This is intended to be printed in TPU and inserted in place of the plug in the end of the arrow yagi antenna tube. I found that holding the end of the antenna against my body while aiming the antenna helped with the weight a lot. This…
- Downloads
- 3
- Likes
- 0
- Rating
- 0
P
PrintablesCozmogeek
Sony ICD-PX470 voice recorder holder
This may work for other sony recorders that use the same sized enclosure but I have not tested that. it is a pretty tight fit so it may require a bit of size adjustment depending on your printer and material.
- Downloads
- 1
- Likes
- 0
- Rating
- 0
These are all currently available results.