Counting matching models…
needs 2 M2x12 (or longer) screws insertion of launchers is counter-intuitive: try it the other way around (last photo) //Edit: as suggested by @samweiss_839166 I added another version for heat set inserts (M3x3x3) and flathead screws.…
Remix of @ChrisAeroEngineering great stackable box with a flat surface on one side for e.g. some sticky notes.
Wall thickness is 1.6mm. Would recommend 4 perimeters/bottom walls and PETG, so no water can creep into the infill.
I was looking for a small drawer for my familiy for floss and toothpicks, so they can't get mixed up - eww. Haven't found anything that fit my needs, so I created a print-in-place solution for that. Size, as in the title: 2x2x10u Magnets:…
Finally a neat place for both my chargers and with just a single outlet! Base and top part printed in PLA Meta, the head stand insert is TPU 98A. I wanted it as an insert to take it out in order to clean it more easily. Also it allows for…
This is a replacement lid for bajohrs led powerlight battery pack. The belt holder broke off, so I needed a replacement. Should it break off again, I can just replace the little belt holder, which prints in around 15min. Requires 2x M3x8…
My son loves building with those blocks and so I got involved, too. I wanted multiple nubs, so I made those. I hope you like them as well. In the future I plan on editing it to remove the holes as they tend to cause stringing and I also…
For those who want easy access to the firmware with an sd-card extension cable. Quick print, it took me around 10 min @ 0.2mm, 3perimeters (as most walls are 1.2mm). print upwards for fracture resistance of tiny back clip; built-in…
Vertical arrangement for powerbanks (max. thickness ~30mm). In the back you can hide the charger itself. At the top, there are holes for heated inserts, as I wanted to put some smartwatch holders there. Do as you like. Print sideways…
Not perfect as the radii were quite difficult to get just right. But better than the broken one. I'd say it's 90% right, it works and I consider my time too valuable to get the last 10% perfect ;) Crappy hacky FreeCAD model included, if…
These are all currently available results.
