Counting matching models…
Couldnt find anything to quickly mount a poti on a wooden board for prototyping. This is for potis with a outer thread diameter of 7mm. This is a 5min design and not rounded / polished / optimized or anything. Feel free to…
Wall mount for Bosch 12V (10.4V) Charger, also (supposedly) supplied with some Dremel models. Its definitely compatible with the Dremel batteries, I use it myself. My charger model number is GAL 12V-20. There are other mounts out there,…
Just an add on I consider useful for making other prints compatible with the honey comb storage wall. The screenshots show you how to add this to any other model. Just make the surfaces barely touch and slice. If you need to place…
End caps for skirting boards from Skandor, type FUG60L replacement part. 2025-10: Added a new sturdier version 2, because the single pin was too fragile. Category: Replacement Parts
This is a top that goes on a 9cm diamter scratch post pipe and is secured by a M8 bolt. The holes for putting in toys are at three different angles and are in 6mm and 10mm. If you put in a pair of F8-16M thrust bearings, it even turns.…
Holder for screwing down the power supply on a board. Print Settings Printer Brand: Prusa Printer: i3 MK4 Rafts: No Supports: Yes Resolution: 0.2 Infill: 100% Notes: If you use Prusa Slicer, the included project already has the necessary…
This is a two piece holder for screwing down a Heschen RE-02 Air regulator valve down on a board. I use it for the air assist on my laser (air comes from a shop compressor, so regulation is needed). Printing is recommended at 100% infill…
These are all currently available results.
