Counting matching models…
This model is inspired by this entry , but modified to fit the 5-Inch version of the TBS Source One frame. It is also a bit easier to print, because I reduced the angle of overhangs. There are different versions of this mount for the…
This model is a remix of MacNeill's TBS Antenna mount . It's been re-designed to more easily fit the spacers of the TBS Source One frame. Also the recess for the pigtail mount is on the other side to more easily mount certain pigtail…
I've been looking for a good tool-holder that fits my needs for a while now. There are a lot of options out there, but I wasn't really satisfied with any of them. I therefore decided to simplify this design and remix it to my liking.…
These parts will enable you to build a sun-shield for your laptop, so you can work in the sun, without glare on your screen. It is specifically designed for use with 5mm thick foam board and laptops with 5mm thick screens , like my Lenovo…
Compatibility This phone cradle fits the center console of the latest series Opel Corsa and Vauxhall Corsa, built from 2019 to present ( Series F ). This includes petrol, diesel and electric models in all trim variants. Features Wireless…
This filament guide fits 4mm (outer diameter) PTFE tubes snuggly. Use double sided tape to mount this clip to your surface of choice.
This is a Case for a Raspberry Pi 3 B+ , mountable on a Prusa i3 Mk3 (S/S+) . It is intended for a headless octopi setup. To hold the case together and fix the Pi in place you need 4x M2x12 Screws. The screw holes do support longer…
This arm protector is designed for the 5-Inch version of the TBS Source One. The 3MF file is set up for four pieces with PrusaSlicer settings for TPU. For easy remixing, I've included the F3D file. Category: R/C Vehicles
Change Log: July 17 2023 Original Upload July 19 2023 Increased size of mounting plates & slots in the fender This allows more movement to accommodate suspension travel Important: Do not glue fender to the mounting plates. It must be able…
The mount is specifically designed for the LED-Lenser P7 flashlight. For additional security, add a zip tie through the hole in the middle of the mount and around the lamp. This adapter lets you mount the flashlight to any common…
Use two or three clips between the spool holders to securely connect them together. These clips click into place in the hexagonal pattern of the spool holder side panels. I highly recommend the Silent Auto-Rewinding Spoolholder , although…
This Kickstand only works in combination with my custom rear fender model! If you don't use this custom fender , print the original Kickstand by @FlyboyEUC instead! This is a remix of @FlyboyEUC's Kickstand model. It is slightly modified,…
When I walk my dog in the park, I love to let her off-leash to explore the area and play with her friends. I then make the leash into a big loop, by clipping the carabiner into the leash handle, so I can hang it over my shoulder. This…
This clip allows you to route a PTFE filament tube along the side of the auto-rewinding spoolholder. I highly recommend the Silent Auto-Rewinding Spoolholder , but this part works with the original version too.
This is an alternative filament guide design for rewinding gravity spool holders like this , this , or many of their derivatives , used in multi-material setups. It allows you to route your filament tubes through a shelve floor and also…
These are all currently available results.
