Counting matching models…
requires support for v1 or flip and print if your bridging is good for v2, two will fit in a cooler. I printed v1 without support and just trimmed and filed the bad overhangs flat to save 50m of filament, thats why I moved the logo and…
modified to fit without tape, shortened the handle both directions about 1cm
made the shelf bigger and the plate stiffer added a 1deg angle to help keep it from tipping forwards
print the lid with supports, i used tree so it was easier to remove
use these when your carrier restricts your train to notch 7, 6, 5 or 4. save yourself a call from the NOC if your have really good bed adhesion you wont need a brim, i use them when i run the full set at once. print them on the side, no…
cut flange to 3mm thick vs original 4mm, bolt heads may need to be ground thinner
print vertically at your desired resolution, can be installed flat or on an angle
6 walls and top/bottom 25% honeycomb, 8x3mm bolts required to mount + rack hardware
After printing I drilled the holes out for ease of inserting m3 screws to clamp the model together. photos are before adding the additional screw mounts, it was fine with 3 but more is better? I used m3x6 but can get by with longer as the…
stock bracket interfered with the part cooling duct used two m3x10 bolts, stock may work, i didn't try switch mounts are threaded, re use stock hardware here print with the long flat edge touching buildplate supports touching buildplate…
These are all currently available results.
