Counting matching models…
I was not satisfied with other seed pod designs for Aerogarden, so I designed my own. The spiral structure is designed to be sturdy for printing without any supports - very low risk of spaghetti as it prints. It fits these seed starter…
Store 8 SodaStream 60L carbonators. Works great to transport them to your store for exchange. Designed to fit the print bed of a Prusa i3. I used PETG but it should be fine to use PLA. For faster printing, use a 0.6mm nozzle and 0.3mm…
17mm inner diameter generic iron mount for the Stealth Press. Built with Onshape using the original CAD STEP file.
Our RV uses a garden hose for the gray water hookup. I designed this to mimic commercial 4-in-1 sewer hookups: 4-inch NPT, 3.5-inch NPT, 3-inch NPT and 3-inch slip fitting. I added some tabs to help screw/unscrew it for the NPT fittings.…
I designed this wall rack to hold the Dyson Humdinger handheld vacuum plus its accessories. This is sized to attach to wall studs spaced 16" apart in a standard US wall. The vacuum can sit upside down, the powered attachment in front, and…
Sand and dirt can get into the mount for the Oru Kayak skeg ; use this protector to keep it clean when you transport or assemble your kayak. When you are ready to insert the skeg, just turn the kayak upside down, remove the protector and…
If the rear plastic body cap gets damaged on your Winnebago EKKO, you can print this replacement part. I reverse engineered this from the OEM part, so it's a close match but not quite identical. The file is for the driver side, but you…
If you enjoy s'mores around the campfire and you have access to a vacuum forming machine, make your own chocolate squares! These are sized to fit a standard half-sheet of graham crackers. Instructions: Print the part with PLA, using a…
This is a remix of the original MagTag case by Adafruit, using standard 8x3mm magnets in lieu of the magnetic feet. It's best for adjacent magnets to have opposite polarity. Attach to the rear of the MagTag using standard M3x8 screws.…
The Precision Circuits 00-10082-124 tank pressure sensor is used in RVs by Winnebago, Forest River and others to monitor the level of your fresh, grey or black tanks. The clearance is tight, so I designed this wrench to help remove and…
With the Prusa XL enclosure from 3D Upfitters, there is no space to store the calibration pin on the side filament sensor. However, you can print this to store the calibration pin on the outside of the enclosure. This prints in place…
These are all currently available results.
