Counting matching models…
A cupholder compatible with the square arm Lovesac couches. It has about 2mm leeway on the arms to allow for printing error without making it a loss and it doesn't hurt the functionality. Added in my new design which uses less material…
It is made with a little wiggle room in each slot so a bit of printing imperfection should not keep it from working. They stay about as upright as the one that came with the sticks so I think it will do fine. Has a small and large size…
The rods are most easily printed by rotating them onto their side and then cutting in half. The halves stay together nicely once installed in the side pieces. I printed with no top or bottom solid layers so the infill shows, which I think…
Designed to keep one bottle of dye upright while you work, as well as holding the cap and dauber off your work area so dye doesn't get everywhere. It has feet on both sides for added tip resistance.
I really liked the original but these sit a little differently on my board and I prefer this mounting style.
Hose adapter to fit a 14 gallon Ridgid shop vacuum with a 2 1/16" (2.0685") hose to a Ryobi miter saw with a 1.65" extraction tube. It fits well but you can add a bit of thread tape if you want more sticking power. Included the model file…
Redwall Abbey extracted from the Abbeycraft Minecraft modpack.
This jig includes a base and slide on cover to hold standard male/male jumper wires in place to make it easier to connect a playstation memory card to your arduino (or other microcontroller) with Memcarduino and MemcardRex to transfer…
Took this great design by Omega-TI and added in some options to hang on a hook or to put 6-8mm magnets in the back. The 3mf has the holes as negative volume modifiers in PrusaSlicer so you can easily tweak it to your preferences. Thanks…
Needed an aglet for craft cord that would also let me add a charm to the end for a dice bag. This has a small amount of spare clearance for the cord to be inserted with some superglue (or similar). Should print with a brim, and support…
Wanted a plug holder for some locks I did not have bodies for and only found designs for SFIC. This will hold LFIC like the Schlage Primus very nicely with a stop at the back. Zero wiggle if printed in TPU/FLEX and gripped in a vise. I…
Different arrangement of the zip tie holes to suit my bike mounting need.
Hole Punch Jig for 1" straps or belts. Meant to work with leather hole punches.
This clip is best printed in a flexible material. It will hold your pen on the tablet by slotting in to the USB charging port on the side for organization or transport if you are not taking your pen stand with you.
-New version with simpler geometry uploaded to get cleaner prints. This funnel is designed for collapsing dog bowls like the one seen in the sample images. There is a loop to hook it to a leash or dish. It also has a lip to help keep…
This skid plate cures with (though does not exactly match) the tail on the Ditch Life model boards and is there to prevent damage from tail stops and dropping off curbs. This is attached with a rivnut ( aka rat nut / sex bolt) and a 12mm…
C Series Padlock Cylinder Clip, meant to emulate the functionality of Mul-T-Lock part LST-CCATCH-PL because the 2 park lock cores are a pain to gut. The STL I uploaded is 5mm narrower than the one in the pictures because that much width…
These are all currently available results.
