Counting matching models…
A box I designed for L23UGSR-5HaxD2HaxD Routerboard. Has 1 open side for air ventilation. Uses M3 bolt to hold the board (M3x6-M3x14) will work. Has mounting points on the backside, which use M4 screws with max ~7mm diameter of the head.…
My Easydry door mechanism broke, the string that you'd pull to open the dryer got torn apart. I designed a replacement. You'll need to print the 2 parts and you'll need an M3x18 bolt and M3 low profile nut. Unlike the original, this works…
We're using these speakers in our meeting rooms in our office and to prevent theft, we decided to mount them to the table using double sided tape. This mount attaches to the cable loop and locks with a single M3x10-16 screw, so it cannot…
Wall mount for 4 channel gate controller Sommer Pearl. Has a slot for easy removal if need be. Made for M4 countersunk screws. V1 might need supports - depending how good of a bridging capabilities you have. V2 does not need supports and…
It's a stand made for rulers. The slots are 5 mm wide. The whole thing is 40 cm wide, 16 cm deep and 2.5 cm tall. Needs to be printed in 2 parts, and then it can be joined using 2 M4x20 bolts and 2 M4 nuts. there are also feet, I printed…
I had my wedding coming and as the saying goes, all I had was a hammer, then everything looked like a nail. But my hammer was a 3d printer. And I had a lot of spare time to come up with idiotic ideas like this one. It's a 3d printed…
I made this to hold slicing disks for Kenwood stand mixer. It requires 10x 6x3mm magnets. It might work without them, but I'd suggest you add them for better stability. Holds 5 slicing disks. Holes on top are for easy manipulation, the…
I lost the included one and honestly, I like my creation way more ;). I have Canyon Exceed and I needed to mount Force Glitz light under the saddle. Your saddle needs to have 7mm mounting rods and they need to be 43 mm apart (not sure if…
These are all currently available results.
