Counting matching models…
I wanted a top tray for my Gaggia Classic to keep things cleaner and ensure no grounds fall down the edges of the lid from storing the tamp up there. The tray uses little material and is a tight fit but because it is thin I think it…
A 3D printable strobe grid for the Bowens S-mount which is standard on a lot of medium or larger studio strobes. The length and size of the grid allows an approximately 20° cone. I would not suggest using this with a non-LED modeling…
I really liked the thin OEM ThinkPhone case, but the plastic fatiqued and cracked quickly. I cloned it as well as reasonably possible and have tested it printed in Polyjet and FDM, both with success. The FDM prints tend to delaminate a…
After trying a few different combo brush+PTFE wipers I was not satisfied. Most of them put the roller too high or in the wrong place so the nozzle collides when the toolhead is parked. The model this is remixed one was the closest to…
I didn't like the look or price of any of the phone mounts available for this era of Forester so I made this. It clips onto the center HVAC duct and only blocks a little of each outlet. The install is permanent (since it seems impossible…
I made this to replace the missing steam knob on my old Gaggia Classic. I don't have the espresso machine anymore so I can't doublecheck fitment, but it worked pretty well except for when I did it in low-temp plastic. Eventually I made a…
I modeled this hotend assembly for X1/P1 OEM type units to serve as a reference when straightening out bent heatbreaks. Since the heatbreaks can bend easily from the plate lugs, chute jams, failed prints, and crashes, I don't want to…
My Rancilio Rocky was missing its tray when I got it so I had to make a replacement. This one fit pretty well, but I only tested it on one machine. I parted ways with my grinder so I cannot double check fitment now but it would be better…
These are all currently available results.
