Counting matching models…
All settings can be standard - except for number of perimeters, which I set to 4 to increase the strength. You do still need to refrigerate your insulin, this case is purely to reduce the chances of breaking your insulin vials when…
This is a 6 battery box for GoPro Hero 9 and 10 Black batteries. It's quite close fitting and doesn't rattle. This version has sharp edges and corners. I will create another version with filleted edges and corners, and perhaps the same…
This is a battery box to hold 4 x GoPro Hero 9 or 10 batteries. It's sized quite snugly so that they don't rattle. If you want more room you could print a few % larger. Category: Sport & Outdoors
I printed this in PETG. I think PLA might be too weak, especially if in the hot sun at a competition. PLA will also shrink differently than PETG, and the friction fit of the lid might not work so well if you use another material than PETG.
A newer version of my 6 battery GoPro battery box, a little stronger and has storage for 4 MicroSD cards. The fit is tight so that the batteries don't rattle. I printed in Prusa PETG, if you use a different filament you might need to…
This ballast box is sized to hold 8 brass ballast slugs and 8 wooden spacers used for the Eternity F5J glider by Bohuslav Majerčík. Print the lid, box and latch in PLA or PETG - I've used both, and then print the gasket in TPU. The hinge…
GoPro stand-alone chargers often fall over when you're putting in or taking out batteries, so this holds three dual chargers neatly and stable on your desk.
This is a light mount for a bicycle trailer that will screw down to a flat surface. Print Settings Printer Brand: Prusa Printer: I3 MK3S Supports: No Category: Sport & Outdoors
This is my copy of the Carry Freedom Y framed trailer light and flag pole mount. You'll still need a 20mm long M6 bolt with a countersunk head and washer and locknut as per the photo, and an M5 grub screw of about 7mm in length. I don't…
Glue this to a JR bay cover and then you have a place to hold a windicator stick to help you find thermals when flying radio controlled model gliders.
These are blanks for Eternity F5J gliders, to space out your ballast. They should be printed with PC Blend or another high temperature resistant plastic. PLA and PETG will almost certainly soften and/or melt in the heat of the sun on your…
These are all currently available results.
